Finish your roof line and protect the fascia board with the amerimax 10 ft.
Roof apron flashings.
They are a combination base and cap flashing that are usually installed behind the siding and caps and over the sloped roofing materials.
Protects fascia board finishes the roof line and guides run off into gutters.
The flashing helps guide run off away from shingles and into the gutters.
Step flashing is a rectangular piece of flashing bent 90 degrees in the center.
Apron angle flashings are one piece l shaped flashings usually on the lower side of a chimney.
White aluminum roof apron flashing.
This drip edge flashing provides protection from water damage along the eaves and rake of a roof.
It is used for roof to wall flashing.
The flashing helps guide run off away from shingles and into the gutters featuring an extended drop provides more protection for the fascia board.
Gibraltar drip edge flashing can be used with asphalt shingles or metal roofing panels.
All roof cladding located at the join except gutters require a flashing fastened on both sides of the join.
An apron flashing is responsible for diverting water from a vertical surface into a gutter system.
The base flashing or apron flashing is the bottom piece.
30 degree white aluminum.
Placed opposite to base flashing or above base flashing counter flashing completes the two part team.
Flashings near the edges of roofs or walls can be subjected to suction or negative wind loads that can be greater than other positive imposed loads.
