Rotating Solar Panel Using Arduino

In general with solar panels it is cheaper to use a bigger panel than to use clever tricks to get more from a smaller panel.

Rotating solar panel using arduino.

Use an arduino two small servo motors with light sensing photo resistors to steer a solar panel towards the sun. The battery will only pull down the solar panel voltage while. To do this put two strips of wood into a t shape. Advantage of this project is that solar panel will always follow the sun light will always face towards the sun to get charge all the time and can provide the supply the maximum power.

The rotating solar panel using arduino project aims at charging a 12vdc battery with the help of a solar panel mounted on platform which can rotate with the help of a motor. The rotating solar panel using arduino project aims at charging a 12vdc battery with the help of a solar panel mounted on platform which can rotate with the help of a motor. It s purpose is to hold the the solar panel up and allow the microservo to adjust its tilt without falling over. This motor is getting controlled by atmega328 microcontroller mounted on an arduino uno board which is in turn mounted on the pcb.

Lastly attach the microservo s gear to the side of the arm. Also there would be no need for the wasteful voltage booster. The volt meter we re using is powered directly from the solar cell. This motor is getting controlled by atmega328 microcontroller mounted on an arduino uno board which is in turn mounted on the pcb.

The rotating solar panel system scans from one horizon to other to know the current position of sun and hence the position from which the greater solar energy can be harnessed. You ll just need two jumpers. Rotating the panels to the east and west can help recapture these losses. The upside to this is that you don t need extra batteries or jumpers.

A solar panel in a fixed orientation between the dawn and sunset extremes will see a motion of 75 degrees on either side and thus according to the table above will lose 75 of the energy in the morning and evening. In this article we are going to make a sun tracking solar panel using arduino in which we will use two ldrs light dependent resistor to sense the light and a servo motor to automatically rotate the solar panel in the direction of the sun light. If this is a problem for you use power from the arduino to run the led volt meter.